Juniper srx show mac address on interface

Queue counters: Queued packets Transmitted packets Dropped packets Physical interface: reth1, Enabled, Physical link is Up Protocol eth-switch, Generation: 284, Route table: 0 Logical interface ae5.0 (Index 136) (SNMP ifIndex 790) (Generation 254) Physical interface: ae5, Enabled, Physical link is Up Protocol eth-switch, Generation: 281, Route table: 0 Marker Statistics: Marker Rx Resp Tx Unknown Rx Illegal Rx LACP Statistics: LACP Rx LACP Tx Unknown Rx Illegal Rx LACP info: Role System System Port Port Port

Logical interface ae4.0 (Index 133) (SNMP ifIndex 788) (Generation 251)ДЇlags: SNMP-Traps 0x0 Encapsulation: ENET2 Minimum links needed: 1, Minimum bandwidth needed: 0 Link-level type: Ethernet, MTU: 1514, Speed: 2Gbps, BPDU Error: None, MAC-REWRITE Error: None, Loopback: Disabled, Source filtering: Disabled, Flow control: Disabled, Interface index: 132, SNMP ifIndex: 606, Generation: 135 Physical interface: ae4, Enabled, Physical link is Up Set interfaces ae5 unit 0 family ethernet-switching Set interfaces ae5 unit 0 description FW01 Set interfaces ae5 aggregated-ether-options lacp periodic fast Set interfaces ae5 aggregated-ether-options lacp active Set interfaces ae5 aggregated-ether-options link-speed 1g Set interfaces ae5 aggregated-ether-options minimum-links 1 } set interfaces ae5 description Trunk_4_FW01-Node1 Set interfaces interface-range ae5-members ether-options 802.3ad ae5 Set interfaces interface-range ae5-members member ge-3/0/21 } set interfaces interface-range ae5-members member ge-1/0/21 Set interfaces ae4 unit 0 family ethernet-switching Set interfaces ae4 unit 0 description FW01 Set interfaces ae4 aggregated-ether-options lacp periodic fast Set interfaces ae4 aggregated-ether-options lacp active Set interfaces ae4 aggregated-ether-options link-speed 1g Set interfaces ae4 aggregated-ether-options minimum-links 1 Set interfaces ae4 description Trunk_4_FW01-Node0 Set interfaces interface-range ae4-members ether-options 802.3ad ae4 Set interfaces interface-range ae4-members member ge-2/0/21 } set interfaces interface-range ae4-members member ge-0/0/21 OK were all done on the SRX until test time, now for the EX Switch Side remember we need two different LACP on the switch to match the two SUB LAG LACP trunks on the SRX, I am using ase4 and ae5 Set interfaces interface-range reth1-members gigether-options redundant-parent reth10 Set interfaces interface-range reth1-members member ge-5/0/11 Set interfaces interface-range reth1-members member ge-5/0/10 Set interfaces interface-range reth1-members member ge-0/0/11 interface-range reth1-membersДЄs always here is the set version set interfaces interface-range reth1-members member ge-0/0/10 On the srx first set the members, you can do this on each interface but I link smaller configs and use interface-range a lot. Ok here is the config Example, we will be configuring a SRX240 Chassis Cluster to have a reth1 LAG of 2G using LACP.

Juniper srx show mac address on interface